Attenuation pad
The d:facto vocal has an attenua-
tion slide-switch at the back of the
mic head. Use a pencil or the like to
activate the attenuator and lower the
output of the head by 10 dB.
Note:
This is to optimize performance with
the Wisycom handle and will not
change the max SPL handling.
Cleaning
Keep the microphone dry and away from exposure to water and
cleaning fluids. Do not use spray or fluid containing chemicals that
could remove static electricity on or close to the microphone. This
could cause permanent damage.
To clean the grid properly without the risk of causing damage to the
capsule, you have to disassemble the microphone head. This requires
a special tool, which can be obtained from DPA Microphones. Please
note that any attempt to take the microphone head apart is purely
at your own risk, and any damage caused in the process will not be
covered by warranty. Be careful not to touch or deform the inner
pop filter, as it will influence the performance of the microphone.
Wired to wireless
The d:facto vocal mic can be used both wired and wireless. It comes
with a handle for wired use, but the microphone body can be
unscrewed from the capsule head and exchanged with a wireless
handle from Wisycom. Please note that all specifications in this
manual apply to the wired handle solution.
Accessories included
DUA0134
d:facto vocal microphone clip
Accessories available
DUA0700
Windscreen
TB4000
Table Base
DUA0250
Floor Base
DUA0500
Stand Extension, 500 mm (20 in)
DUA0100
Stand Extension, 100 mm (4 in)
FAHV1B
d:facto handle
MMH4018V11B d:facto vocal microphone head
DQA0025
Mic head opening tool
dB
10
0
-10
-20
-30
20 Hz
50
100
200
500
1 kHz
2
5
10
20
40
Frequency response
Measured at 12 cm (4.7 in)
250 Hz
500 Hz
8 kHz
16 kHz
4 kHz
2 kHz
1 kHz
5 dB
Frequency Response
Polar Pattern
