Doyon DRIP1, Руководство пользователя

Страница: 7 / 49

A5
OPERATION OF THE DIGITAL CONTROL
1. Turn the main switch to " 1 ".
2. The light inside the proofer will turn ON and the digital control will indicate a code. Then,
"PREH" will flash.
3. "PREH" will be displayed on the control until it reaches the set temperature.
To check and modify:
Temperature settings : Press and hold down for 2 seconds the temperature key
and adjust with the UP and DOWN arrows. Then, press
temperature key to save data or " red " to exit
without saving.
Humidity settings : Press and hold down for 2 seconds the humidity key and
adjust with the UP and DOWN arrows. Then, press
humidity key to save data or "red " to exit without
saving.
4. When the control reaches the set parameters, "PREH" will disappear and the timer display will
appear.
To start the timer, press " green ", the timer will stop blinking and start countdown.
At the end of the countdown an alarm will go off and " READY " will appear on the display.
Press " red " to stop the alarm.
5. When proofing cycle is completed, turn OFF the switch.
When the proofer is not in operation, open the doors to let out the humidity and prevent
mould.
P.S. The doors should not be opened unnecessarily to conserve the heat and humidity in the
proofer. The water pan under the proofer's doors should be cleaned daily.
POWER FAILURE
When the power comes back, the proofer will start automatically. It is recommended, when a power
failure occurs, to turn off the unit in order to avoid it from starting without supervision.