MODULRAM DIGITAL |
Edition A - Revision 0
Instruction Manual |
6
3 | First time heating process (control panel
8090
)
Ramalhos mode
F t
r A
Oven Function test
Ramalhos mode
F h
r A
First heating of the oven.
First heating of the oven
Ramalhos mode
“
n
” corresponds to the present phase
and “
6
” is the number of the first time
heating programme phase
F h
r A
n - 6
TOP temperature
Remaining time of the corresponding
maintenance or resting phase
STONE temperature
1 0 0
1 5
1 0 0
First heating of the oven
Ramalhos mode
End of first heating process
F h
r A
E n d
Heating the oven for the first time is extremely important
to ensure its future proper functioning and avoid structural
problems. The first heating programme must be executed
in full and only after it has been completed does the con-
trol panel enter normal operation mode. If there is a power
cut, the programme will restart in the last temperature re-
When the oven is turned on for the first time it will
automatically enter Ramalhos mode and show
the message:
funtion test
and
first Heating
on
the display of the control panel. You can use the
and , buttons to select one of the operation op-
tions shown alternately on the display:
1) function test
:
It is used to check the oven is functioning properly after in-
stallation. During this phase the oven temperature will not
surpass 50º C. To initiate the function test press the but-
ton.
corded with a 25ºC margin. To start this programme press
the button.
+
note
To return to Ramalhos mode, press the
button to
turn the oven off and on again.
–
The whole process will be managed automatically by the
control panel.
Throughout the process the display will alternately show dif-
ferent information, namely:
END OF FIRST HEATING PROCESS
Once all stages of the first heating programme are complet-
ed the control panel will show the following information:
2) first time heating the oven
note
The first heating process may take up to 6 hours.
Finally press
, you may now start the baking cycle.