Dovre TAI 45C, Инструкция по установке и эксплуатации

Страница: 51 / 224

Burning brown coal
briquettes (TAI M)
Brown coal briquettes burn in almost the same way as
wood. Using the primary air inlet, ensure sufficient
supply of air under the fire. For further information see
the paragraph "Burning wood".
Burning brown coal briquettes creates a lot of ash.
Regularly remove excess ash. See the paragraph
"Removing ashes" for instructions.
For the properties and use of brown coal bri-
quettes: consult your brown coal briquette sup-
plier or see the brown coal briquette packaging.
After you have followed the instructions for lighting:
1. Slowly open the door of the appliance.
2. Spread the charcoal evenly across the bottom of
the stove base.
3. Place the brown coal briquettes on the charcoal
bed.
4. Close the door.
Burning anthracite coal (TAI
M and TAI C)
When burning anthracite coals, always close
the secondary air slide and set the plate (this is
the fuel choice selector) in the back wall to pos-
ition 1. See “Fuel choice” paragraph (TAI M)”.
Burning coal without bunker
After you have followed the instructions for lighting:
1. Open the primary air slide completely.
2. Slowly open the door of the appliance.
3. Spread the charcoal evenly across the bottom of
the stove base.
4. Spread a shovelful of coal on the charcoal bed and
wait with the next shovelful until the coals start to
glow.
5. Now add more coal.
Be careful not to smother the fire by adding too
much coal at once.
You have added as much as you can when the
glow from the previous load is only just visible.
6. Close the door.
7. Allow the coal to burn well for a few minutes and
then set the thermostat to the desired position.
If the coal basket begins to glow red, the fire is
burning too strongly.
Burning coal with bunker
After you have followed the instructions for lighting:
1. Open the primary air slide (thermostat) all the way.
2. Slowly open the door of the appliance.
3. Spread the charcoal evenly across the bottom of
the stove base.
4. Close the door.
5. Slowly open the filling lid in the top plate.
1
2
09-20020-359
6. Fill the bunker with coal to below the rear openings
in the bunker.
7. Close the filling lid.
8. Allow the coal to burn well for a few minutes and
then set the thermostat to the desired position.
The filling frequency depends on the output
demanded.
To keep the stove burning at night, the ther-
mostat is turned down to around position 1.
Subject to change because of technical improvements
19