Astroline 2
6
03.27605.000
3.2. Preparing the stove
Please inspect the stove for damage caused during transport immediately after de-
livery and notify your distributor in case there are any defects. Do not put the stove
into operation in the meantime.
In order to avoid damaging the stove during installation and to make handling of the
stove easier, it is recommended to remove previously all loose parts (top plate, fire-
resistant bricks, grille, ashtray, ...) from the stove. Note the location of those parts
while removing them, so that you have no difficulties in re-assembling the parts
later on.
The stove will be supplied with the following parts:
•
A connection collar
•
A blanking plate to seal off the connection opening
•
A small shovel to remove ashes = a "cold hand" to remove the ashtray
3.2.1. Assembling the inner part of the legs
Assembly the inner part of the legs using the bolts: see figure.
3.2.1. Smoke outlet
Your stove is suitable for two connections: a
top or a rear connection.
Upon supply, the top and rear exhausts have
been left open. Depending on the position cho-
sen, one opening can be covered with the
blanking plate supplied; the other one can be
equipped with the connection collar supplied
(see picture). Use the fixings supplied and be
sure to tightly seal the connection collar and
the blanking plate to the stove by means of the
kit or paste supplied.
In order to make the connection easier, the top
plate may simply be removed from the stove
and replaced afterwards.
