Dover MagLink LX4, Руководство по установке

Страница: 15 / 37

6.3 Electrical Connection
To make a connection to 220 VAC:
l
De-energize all power switches at the main electrical panel.
l
Make sure to use the applicable connections to connect the console to the electrical panel.
l
For power connections, use a single-phase cable, a section of which is not less than 1.5 mm
2
and
one which is sufficiently protected. The power cord must comply with the standards IEC 60227 and
IEC 60245. The cable supplied with the console already complies with these regulations.
l
Make sure the power plug is connected to the ground and protected against short circuits and
power surges.
l
Make sure to connect the I.S. ground to the site's earth system. Use a dedicated 4.0 mm
2
copper
cable (see the illustration below).
.
l
The power cord must be easy to identify and must have easy access so it can be used to remove
power.
WARNING: There is high voltage within the console.
IMPORTANT: The electrical connection procedure must be done by approved personnel
only!
M2050 MagLink LX 4 Installation Manual | Dover Fueling Solutions 15