Filter Installation Instructions
Operating conditions
Maximum working pressure: 6 bar (90psi) - see note* on page 4
Maximum working temperature: 30°C (86°F)
Minimum working pressure: 1.4 bar (20psi)
Minimum working temperature: 5ºC (41ºF)
Maximum plastic housing life: 10 years - see note* on page 4
PLEASE NOTE: Allowing the unit to freeze will invalidate the product
warranty
Important
1. This filter is intended for installation under the sink away from direct sunlight
2. This filter is not designed for the treatment of hot water and should only be
connected to the cold water supply
3. It is important to wear rubber gloves or wash your hands thoroughly before
and after servicing the filter
4. Care must be taken at all times to prevent contamination of the neck of the
filter cap and stem of the filter element mount by contact with unfiltered
water or dirty hands after cleaning the filter element surface
Connecting Pipework and Fittings for either the 1/4” or 3/8” models:
The filter is supplied with pushfit connections. Medium density polyethylene tubing
from a reputable supplier is recommended. An isolation valve and non-return valve
should be fitted upstream of the filter (these are required by law in the UK).
The isolation valve may be used to regulate the maximum flow rate in
accordance with the requirement of the filter element used. Having selected the
appropriate fittings, a user valve/faucet should be installed in accordance with
the manufacturer’s instructions in a convenient position and then connected
downstream of the filter.
www.doulton.com
A GENUINE WATER FILTER
A GENUINE
WATER FILTER
Filter element
mount
Filter
head
Filter cap
Filter body
Neck
Figure 1
