!
!
WARNING
*BECAUSE OF THE SIZE AND WEIGHT OF THE SYSTEM, A MINIMUM OF
THREE ADULTS ARE REQUIRED FOR THE FOLLOWING STEPS*
STEP1
6
STEP2
A. Slide the Main Extension Arm(F) over the top of the Main Post (A)
and attach to the lower pivot tube with a M18 x 12.6” Hex Bolt (#5),
two M18 Flat Washers(#11), two Nylon Washers M18 (#1) and one
Lock nut M18 (#14).
Do not over tighten this bolt and nut.
Note: make sure Nylon washers locate between Main Extension Arm (F) and Post (A).
The Nylon washers may be factory-assembled.
Slide a 16mm Thick Washer (U3) over each of the J-Bolts (U2) as shown in FIGURE 1A.
Remove the Padding from Main Post (A). Place the Main Post (A) over the J-Bolts. Slide a
16mm Thick Washer (U3), a Lock washer 16mm (U6) and thread a 16mm Hex Nut (U4) to each
J-bolt. Tighten the Nuts only a few turns onto the J-Bolts as shown in FIGURE 1B.
If the Main Post (A) is not exactly vertical, adjust the 16mm J-Bolt Hex Nuts (U4) located under
the Post base. Tighten all of the Hex Nuts (U4) Above Post base when Main Post (A) is vertical.
NOTE: Face the Main Post (A) with Actuator Bracket facing away from playing court (as shown in FIGURE
1C).
A.
B.
C.
Nylon washer #1 may
be factory installed
U6
U3
U4
FIGURE 1B
Playing Court
Back
FIGURE 1C
FIGURE 1A
U3
U2
5
11
1
F
14 11
Rubber pad face up
B. Install stop pin through designated hole and secure with ring
