3
injury or damage to the filter system. Starting at least
12" from the pool wall, make two 3-4" deep trenches,
one from the pool's skimmer toward the front of the
pump and the other from the pool's return fitting toward
the filter port located on the tank cover, marked "TO
POOL". Be sure the hoses are routed so that water flow
through them is not restricted.
POSITION FILTER ON TANK BASE
Position filter in the tank base with the tank port labeled
“TO PUMP” oriented to the pump discharge as shown
in Fig.s 1 or 2.
IMPORTANT:
After orienting the filter on the pad, and
prior to filter start-up, you must install the tank o-ring.
Loosen the v-clamp and remove it and the cover. Install
the o-ring onto the tank flange. Reinstall the cover,
being sure that the o-ring is seated into the cover
groove. Reinstall the v-clamp and tighten.
Did you read the
IMPORTANT SAFETY INSTRUC-
TIONS?
If not,
READ THEM NOW.
They contain very
important safety information related to the installation of
your filter.
Familiarize yourself with the installation sequences by
reading these instructions first.
AVOID SHORTCUTS
that may result in reworking the installation.
BEFORE YOU BEGIN
The pool must be properly erected per your pool
assembly and installation instructions before installing
the filter. Install the surface skimmer and return fitting.
Before completing the filling of the pool to the water
level indicator marks on the skimmer face plate, the filter
and pump should be installed with all connections
securely tightened.
TOOLS REQUIRED
• Flat head screwdriver
• Crescent wrench
• Measuring tape
• Carpenters level
• Flat nose shovel
• Rags
• 5/16" Nutdriver (optional)
The following tools are required for hard plumbing:
• Hack saw
• File
MATERIALS REQUIRED
• Nine 12" x 12" patio blocks (All filters)
The following materials are required for hard plumbing.
• 1-1/2" Schedule 40 PVC pipe
NOTE: Quantity depends on length of pipe
runs desired.
• 10 to 12 1-1/2" 90 degree socket PVC elbows
• PVC pipe primer
• ABS to PVC solvent cement with applicator
INSTALLATION
INSTALLATION LOCATION
Install your filter and pump and any other related
components at least 4 feet from the pool to prevent their
being used as a means of access to the pool by young
children. Patio blocks provide firm support and keeps
standing water and weeds away from electrical parts.
DO NOT install your filter and pump directly on the
ground surface. Settling and stressing of the circulation
lines may occur during wet seasons. Position patio
blocks as shown in the following illlustrations, using a
shovel and carpenter’s level to level ground before
placing the blocks.
POSITIONING FILTER/PUMP
Position filter and pump on pad as shown in Fig. 1 for
hose installation, hoses not included, or Fig. 2 when
hard plumbing.
Suction and return lines should be partially buried to
prevent accidental tripping that could cause personal
RETURN
FILTER
SKIMMER
PUMP
PUMP
FILTER
4 FT.
RETURN
SKIMMER
FIG. 1
Hose Installation
FIG. 2
Hard Plumb
Installation
4 FT.
