DOTWORKZ HD12-CD-HB, Руководство по установке

Страница: 8 / 16

8
2.2.2 Hold the Wall Mount up to the desired mounting location. Ensure that the mount is level
and oriented properly in the correct location. Using the Wall Mount as a template, mark the
4 mounting holes for drilling. There are two suitable mounting patterns to allow for
installation flexibility, as indicated below. With the hole locations marked, set the Wall
Mount aside for later use.
2.2.3 Use a hammer drill to make 3/8 inch diameter holes at each of the 4 mounting locations
marked in the previous step. A hammer drill is
required for this operation. Clean the holes
of all concrete dust using a wire brush and compressed air or a vacuum. Install the 3/8-16
concrete anchors in each of the 4 drilled holes by hammering them in to the appropriate
depth. Leave the nut on while hammering so that the threads of the anchor are not
damaged. Ensure that the Wall Mount fits over the concrete anchors, and then set it aside.
Warnings:

The supplied anchors are for concrete only. Do not attempt to use in brick, block, or other
materials. Other fasteners are required for brick, block and other materials and are not
included. Minimum engagement of the supplied concrete anchors is 2” [50 mm]. If the
provided fasteners are not appropriate for the installation surface, it is the responsibility of
the customer to specify and source appropriate fasteners for the application.

Holes for concrete anchors should be drilled a minimum of 1/2 inch [13 mm] deeper than
the overall length of the anchor, provided that the mounting surface can tolerate such a
depth. This allows the anchor to be hammered flush should a mistake be made or a location
change be necessary.
HOLE PATTERN 1
HOLE PATTERN 2