PL31--15LS2
02/00
Page 10
Angle Head
Assembly
Part Number
Assembly
Includes
Output Spindle
Part Number
Spindle
Thread Size
(Internal)
1025314
1025409
1025313
1025328
1019553
1019551
1019552
1019554
#10--32
1/4”--28
9/32”--40
5/16”--24
--61
--62
--63
--64
LUBRICATION
Only Molykote is recommended for use in these angle heads.
Wipe on only a small amount and remove any excess.
REASSEMBLY (With new components)
1. Start with only one 0.002” shim
(part #1006265)
above work
spindle in bearing pocket. Assemble all output spindle
components, applying Molykote, and tighten bearing cap to 15
inch--pounds torque.
This is for
end play
only. With too much play, take out the
0.003” shim. A slight back--and--forth amount of play is
acceptable and necessary.
2. Assemble all remaining components and check gear
“shake”. This is for
gear mesh
which should be no more than
0.005”.
3. Be sure to apply Molykote before assembly.
1019759 Spanner Wrench (service
wrench
not supplied
with angle
head assembly).
Fits #1019569 Bearing Cap
1009643 Spindle Extension
•
1019559 Ball Bearing
•
1019555 Bevel Gear
1006205 Retaining Nut
=
•
1009087 Ball Bearing
1008748 Shim — 0.002”
1013224 Shim — 0.005”
As
Required
1019569 Bearing Cap
(LH Thread)
1019556 Angle Head
(Includes #1008992
Grease Fitting)
•
Output Spindle
(see chart, above)
1”--20
LH Thread
•
1019559 Ball Bearing
1006265 Shim (0.002”)
1006266 Shim (0.003”)
1006267 Shim (0.005”)
As Required
=
(
=
) NOTE: ALWAYS replace Bevel
Gear and Output Spindle
IN PAIRS
since both should wear equally.
Tighten to 15
Inch Pounds torque.
3/8” Hex
•
1019560 Ball Bearing
Models 15LS & 15LN Angle Drills
90º Miniature Angle Heads
DOTCO
Termination
Code
(
S
) Indicates recommended spare part. Order
one (1) or one set for every 6--10 tools. Small,
easily lost or low cost parts should also be
ordered on the basis of 3--4 per 10 tools.
