Installation
During installation of the spot, it should be ensured to leave a space of approx. 4 cm
around the heat sink. The spot can be installed on vertical or horizontal surfaces.
1.
Loosen the mounting bracket by loosening the two Allen screws from the spot.
2.
Bring the mounting bracket into the desired position and mark the two oblong
holes on the mounting surface. Drill the two mounting holes into the surface
using a suitable drill with 6 mm in diameter and insert dowels into the holes. The
dowels included in the scope of delivery are suitable for installation in concrete,
stone and masonry. In case of wooden substrates the mounting bracket can
directly fixed using the supplied screw, without the dowel. In case of hardwood the
holes may require pre-drilling.
3.
Position the mounting bracket over the dowel and screw it down with the supplied
screws. The oblong holes allow to carry out fine adjustments.
4.
Now, the clar 50/100 can be attached to the mounting bracket. Please observe
the order of the fastening elements: A plastic washer is put between the spot and
the bracket and directly under the screw head, there is a lock washer. After align-
ment of the sport, tighten the Allen screws using the Allen key supplied.
Electrical connection
Carry out the cable connection according to the following drawing. The power supply
should be installed near the spot, in a place which is protected from weather conditions
like sun, snows and rain. The connection of the power supply is to be carried out via the
shockproof plug, or directly in a suitable junction box or connection sleeve. Connections
must only be carried by a qualified expert!
Apply the mains voltage only after connecting the spot to the power supply. Hand tighten
the knurled nut at the connection plug - when tightening the nut, there must be detect-
able engaging.
Installation / Electrical connection
12
GB
clar 50 / 100
Connector
Shockproof plug
Power supply
