14
FRUs
Enclosure bezel for 24-drive model
The SFF 24-drive enclosure supports a bezel sub-assembly that attaches to the front of the chassis (see
). The bezel—comprised of a vented cover featuring integrated ear caps—is pre-assembled and
packed with foam into a box included in the master shipping container.
NOTE:
The enclosure bezel geometry shown in illustrations within this document may be slightly different
than the bezel shipped with your product, but the ball stud attachment points are the same.
Bezel attachment and removal instructions are provided beneath
Attaching and removing the enclosure
Figure 5
Partial assembly showing bezel alignment (2U24)
Ball stud on chassis ear
(typical 4 places)
Enclosure bezel sub-assembly
Pocket opening (typical 2 places)
