Dot Hill Systems SANnet II 200, Инструкция по установке, эксплуатации и обслуживанию

Страница: 29 / 186

3-1
CH A P T E R
3
Unpacking Your SCSI Array
This chapter describes the procedure for unpacking the SANnet II 200 SCSI array
package. Topics covered in this chapter are as follows:
■
“Opening Your Package” on page 3-1
■
“Checking the SANnet II 200 SCSI Array Package Contents” on page 3-2
■
“Field-Replaceable Units” on page 3-3
■
“Customer-Provided Cables” on page 3-3
■
“Mounting Your Array in a Rack or Cabinet” on page 3-3
3.1 Opening Your Package
Follow these guidelines for unpacking the equipment.
Caution –
Always use two people to remove the unit from its container, to avoid
personal injury or damage to the equipment during installation. A fully loaded unit
weighs approximately 57.2 pounds (26 kilograms).
1. Select a suitable area for unpacking.
2. Store all packing material and boxes for possible equipment returns.
3. Check the Contents Sheet in your product package. See “Checking the SANnet II 200
SCSI Array Package Contents” on page 3-2.
The Contents Sheet summarizes the standard contents for your product.
4. Compare the packing slip and the list of parts with the items you received.
If the list of parts on your packing slip does not match the items you received, or any
items appear damaged, immediately notify your carrier agent and the supplier who
prepared your shipment.
5. Carefully examine the cables provided in the package.
If any cable appears to be damaged, contact the Technical Service department for an
immediate replacement.