Setting the spray pattern
Fig. 17: Setting the material flow
1. Set the material quantity by turning the
material flow control (1).
Right turn: Reduce material quantity.
Left turn: Increase material quantity.
Fig. 18: Set spray width
2. Set the spray width by turning the flat jet
setting (2).
Right turn: Minimize spray width.
Left turn: Maximize spray width.
6
Operation
6.1
Safety recommendations
WARNING!
Danger of explosion due to chemical
reactions
Material, halogenated hydrocarbon-based
rinsing agent or cleaning agent can chemi-
cally react with aluminum components of
the product. Chemical reactions can cause
explosions. Serious injuries and death can
be the consequence.
– Only use rinsing agents and cleaning
agents that do not contain any halo-
genated hydrocarbons.
NOTICE!
Material damage due to dried material
residues
If material residues dry in the product, that
can harm components.
– Rinse product immediately after each
use.
6.2
General notes
1. Perform the following checks during oper-
ation:
Check O-rings for correct seating and
tightness.
Check air car for cleanliness.
Check nozzle for cleanliness.
6.3
Selecting air cap
The spray gun is suitable for different appli-
cations. The selection of the air cap deter-
mines the area of application.
Operation
11/2019
EcoGun AS MAN EC - MSG00022EN
13/52
