Doro IP880 DECT, Руководство пользователя

Страница: 35 / 44

32
www.doro.com
Provisioning
This section describes how to provision the phone using hosted configuration server and
hosted firmware update server. The servers can either be a TFTP server or a HTTP server.
From the production the phones are configured to retrieve firmware from an Doro hosted
server (http://www.doro.com/downloads/ip880dect/upgrade/). The Doro server should
normally be kept as Firmware server unless you network topology requires differently.
If there is more than one phone to configure it is recommended to write the settings into a
configuration file and place it on a boot server (HTTP or TFTP). The filename consists of
the phone’s MAC address and the extension “cfg” (001d29000a11.cfg). Press the “volume
up” key on the handset in idle mode to obtain the MAC address. A MAC address label is
also placed on the bottom of the gateway and on the box.
System Requirements
When using a provisioning system for the phone, it can consist of the following servers:
Configuration Server: HTTP or TFTP server holding configurations such as account
information, CODEC priority setup, SNTP timeserver configuration, time zone, etc.
The configuration will be retrieved by the telephone as a text file. Optionally the file can
be AES encrypted.
Firmware Update (Boot) Server: HTTP or TFTP server holding binary firmware
images for remote firmware upgrading of the telephones. In addition the server makes
textual release description available for the end-user through the phone’s user interface.
The servers can be placed on the Internet or on a local area network (LAN).
Setting up the Network
By default (factory setting), the phones are configured to use HTTP as the transfer protocol
for provisioning. TFTP can also be used. The boot server address can be an IP address, a
fully qualified domain name (FQDN), or an URL.
Initiate the download of the configuration files from the handset by selecting Settings /
System Settings / Restore settings . The gateway will reset and request the
configuration file from the preset location.
The preset address can be found at Management Settings / Configuration server
address : via the web interface.
Note! When the gateway is reset, any active calls will be dropped.
Setting up the Boot/Update Server
The following describe a configuration server.
Install boot server application or locate suitable existing server(s).
Create account and home directory.
Create /Config subfolder.
•
•
•
•
•