Doro CareIP Mobile, Руководство пользователя

Страница: 19 / 44

19
Programming
Contacts, alarm codes and settings are programmed using a computer and the CS2
software or via an automatic download procedure from i-care online.
For help with programming, please refer to the service manual or contact your
supplier.
In some cases, the CareIP can be delivered pre-programmed by the supplier.
Programming radio triggers
Up to ten radio triggers or other radio-alarm transmitters can be programmed.
Programming radio transmitters:
•
Hold down the green button for approximately four seconds until the unit emits a
beep, release the button. The “On” light flashes green.
•
Press the radio trigger. Once the CareIP receives the radio signal, you will hear
a distinct tone signal.
•
Confirm by pressing the red button on the carephone.
Check radio coverage
This should always be done on installation.
•
Hold down the green button for approximately four seconds until the unit emits a
beep, release the button. The “On” light flashes green.
•
Press the radio trigger. The built-in speaker will sound a tone signal on
successful reception. Repeat this in all areas where the alarm needs to operate.
Functional test
Always check the function after installation and programming. Test alarms shall be
done regularly and in a way that secures the whole alarm chain from radio transmitter
to alarm receiver.