Dorner 3200 Series, Руководство по установке

Страница: 9 / 58

851-703 Rev. A 7 Dorner Mfg. Corp.
Aluminum Conveyors
Assemble
4. Join conveyor sections and install frame connector
plates
(Figure 6, item 1) or connector/mount brackets
(Figure 6, item 2) and screws (Figure 6, item 3) on
both sides as indicated. Tighten screws to 60 in-lb (7
Nm).
Figure 6
Figure 6
5. With a 5 mm hex-key wrench, rotate pinion gear
(Figure 7, item 1) to tension the conveyor belt. Tighten
fastening screws (Figure 7, item 2) on both sides of
conveyor to 80 in-lb (9 Nm). For proper tensioning,
refer to “Conveyor Belt Tensioning” on page 12”.
Figure 7
Figure 7
6. Install mounting brackets and return rollers. Refer to
“Attach Mounting Brackets” on page 7 and “Install
Return Rollers” on page 8.
7. If equipped with cam tracking assemblies (Figure
4, item 3) , reposition and adjust belt tracking. Refer to
“Conveyor Belt Tracking” on page 13.
Attach Mounting Brackets
1. Locate brackets. Exploded views shown in Figure 8 and
Figure 9.
Figure 8
Figure 8
Figure 9
Figure 9
2. Remove screws (Figure 8, item 1 and 2) and (Figure
9, item 1 and 2) , washers (Figure 8, item 3) , nuts
(Figure 8, item 4 ) and T-bars (Figure 8, item 5) from
brackets.
3. Insert T-bars (Figure 8, item 5) and (Figure 9, item 5)
into conveyor side slots (Figure 10, item 1) . Fasten
brackets (Figure 10, item 2) to conveyor with mounting
screws (Figure 10, item 3) .
1
3
2
2
1
1
5
4
3
2
5
1
4
3
2