INS SSRLS_SSRLU-3 v10.2.vsd Created: 5-14-2018 Revised: 5-14-2018
Page 3
The locksets are handed. When unlocked, the lever should
always point upward.
3- Point Horizontal Lock Installation
DOOR MARKING & DRILLING:
IMPORTANT:
Make sure the door swings free and smooth before
you begin the installation. Remove all old locks, exit devices, any
slide bolts or other hardware & brackets. Make sure any exposed
holes left from previous hardware are completely covered after
installation.
Make any adjustments to make the door swing FREELY
before you start marking and installing.
1) Mark a horizontal reference line on the corridor side of the
door, at a height of 44" from the bottom of the door (not
floor). Extend the line to the hinge side of the door.
2) Align the template with the horizontal reference line and
the frame stop then tape it to the door. Please refer the
cardboard template to mark and drill the holes. Drill
(4) 3/8" through holes (TIP: Start with 1/8"). Make sure you
drill level.
5) Select a location for the height of the top module
(suggested at a height of 25-1/8"" from the horizontal
reference line). Mark a horizontal line approx. 12" from the
lock edge of the door. Make sure the line is level.
6) Select a location for the height of the bottom module
(suggested at a height of 35-18' from the horizontal
reference line). Mark a horizontal line approx. 12" from the
lock edge of the door. Make sure the line is level.
7) Draw two vertical lines, one at a distance of 2-3/16" and
another at a distance of
5
-
3/16”
from frame stop on the top
and bottom horizontal module lines.
8) Punch the center point at vertical and horizontal lines
intersect as shown. Drill pilot holes first. Drill (2) top holes
and (2) bottom holes of 3/8" dia. through the door.
A
CORRIDOR SIDE OF THE DOOR
Stamped Washer &
Carriage Bolt Assly.
B
ROOM SIDE OF THE DOOR
C
D
E
Select a height
which is
comfortable
for users
Select a height
which is
comfortable
for users
44"
(suggested)
IN-SWING MODEL
Upper Module
Lower
Module
Main Lock
Body
Bolt
Extended
Fr
am
e
M
ai
n B
ol
t S
tri
ke
CORRIDOR SIDE OF THE DOOR
44"
(suggested)
Cardboard
Template
Fr
am
e
44"
(suggested)
Reference Line
Reference Line
35
–
1/8
”
IN-SWING MODEL
IN-SWING MODEL
ROOM SIDE OF THE DOOR
A
B
B
C
D
E
2
-
3/
16
”
2-3/16"
Stamped Washer
Stamped Washer
E
5-3/16"
5-3/16"
SSRLS-3 / SSRLU-3
IN SWING MODEL
Installation Instructions
E
SSRLS / SSRLU
Cardboard Template
Main Lock
Body
Select a height
which is
comfortable
for users
Select a height
which is
comfortable
for users
Carriage
Bolt &
Washer
Assly.
