WATCHMAN Installation Instructions
Page 8 For Assistance: [email protected] (909) 591-8431 PID1244R6-6
Alarm Duration Setting
To change the alarm duration setting:
1. Using a right-angle #2 Phillips screwdriver, remove the
metal lens cap guard on the Main End cap.
2. Using a Phillips screwdriver, remove the red lens cap.
3. Locate the SW1 switch & select 4 SEC or 8 SEC.
[Figure 10]
4. Replace the red lens cap.
5. Replace lens cap guard.
Tools Required:
• Right-Angle #2 Phillips Screwdriver
• Phillips Screwdriver
Fig. 10
Fig. 10
Under normal usage, fresh batteries will last approximately 1.5 - 2 years. When the batteries are in need of
replacement, the Watchman will begin to chirp once every (5) minutes.
Due to operational variables, it is not possible to calculate how long the Watchman will operate after the low-battery
alert begins. For this reason,
batteries should be replaced promptly after the low-battery alert begins to sound.
Low-Battery Alert
NOTE
There is no need to reset or power down after the change is
made. The change takes effect immediately.
