dormakaba registration unit 90 01
Quick Guide
04047655 - 01/2020
3/4
Flush cable mounting
To achieve the ingress protection to IEC 60529 specified in the
technical data, the back housing must be mounted to the de-
livered black sealing mat (2). It is used to balance out any un-
evenness and to improve water resistance.
The back housing (1) is mounted on a flush-mounted or cavity wall
switch box using suitable fastening screws (not included in the
scope of delivery). The cable entry takes place from the back.
Surface cable mounting
For surface cable mounting, the cable entry can take place from
below or from the side. First the respective cut-outs in the back
housing with spacer frame (1) must be produced. A loop (siphon)
should be provided, so that no water can enter. The back housing
with spacer frame (1) can be screwed or glued to the surface.
Connecting the coaxial cable
Terminal
Connection
6
Shield of coaxial cable (S)
7
Central conductor of coaxial cable (+)
Switch settings
On the back of the front panel there is a switch bank for setting
the received signal strength (RSSI value).
This switch bank can be used to set or limit the range of Mobile Ac-
cess via Bluetooth Low Energy (BLE).
1
2
3
4
RSSI [dBm]
OFF
OFF
OFF
OFF
BLE OFF
ON
OFF
OFF
OFF
-30
OFF
ON
OFF
OFF
-32
ON
ON
OFF
OFF
-34
OFF
OFF
ON
OFF
-35
ON
OFF
ON
OFF
-36
OFF
ON
ON
OFF
-37
ON
ON
ON
OFF
-39
OFF
OFF
OFF
ON
-42
ON
OFF
OFF
ON
-47
OFF
ON
OFF
ON
-53
ON
ON
OFF
ON
-60
OFF
OFF
ON
ON
-74
ON
OFF
ON
ON
-94
OFF
ON
ON
ON
-111
ON
ON
ON
ON
-128
The RSSI value can be changed if necessary. Higher values allow
the recognition of smartphones over longer distances. Smaller val-
ues reduce the range and increase safety. A compromise between
security requirements and operability is recommended.
Final mounting
Place the front panel with electronics on the back housing as fol-
lows:
NOTICE!
If proceeding incorrectly, the pin header may become
damaged!
1.
Slide front panel in parallel onto the back housing.
2.
Press the front panel against the back housing, until it audibly
locks into place at the top and bottom.
3.
Remove the protective film.