INSTALLING LOCK
1. Locks are factory pre-set with
for 1 3/4" thick door.
Lock can be
adjusted for 1 5/8" to 1 7/8" door thickness.
To Adjust For Another Door Thickness
Remove outside lever.
Figure 3
If adjusting for doors thinner than 1 3/4"
thickness, split spacer must be removed.
2.
For 1 3/8" doors
Adjust for 1 5/8" door thickness, then install
spacer rings (Fig. 5).
NOTE;
DORMA
rings
not included.
Part Numbers 76001941[Brass], and
76001942 [Chrome].
3.
Reinstall outside lever.
Figure 5
CONVENTIONAL CYLINDER
(Fig. 3)
A. Turn key in cylinder 45 degrees in either direction.
B. Depress outside lever catch with wire pin through
small hole in rose/lever and pull lever off tube.
IC CORE CYLINDER
(Fig. 4)
A. With IC core removed, use screwdriver inside
lever to depress lever latch.
B. Pull off lever.
Figure 4
DOOR THICKNESS ADJUSTMENT
Optional Spacer Rings For
1 3/8" Thick Doors
(2 Required)
# 76001941 Brass Finish
# 76001942 Chrome Finish
PAGE 2
Wire Pin
IC Lever Catch
Figure 1
PREPARE LOCK
1.
Remove inside lever. Depress the lever catch
with the wire pin through the small hole in the
rose/lever and pull lever off the tube.
2
. Depress lever catch again and remove the
inside rose assembly.
INSTALL LOCK
1
. Push lock through 2 1/8" hole from the outside
so that retractor engages latch tail.
2.
Prongs must engage inside lock housing.
3.
Align outside rose so rose post enters thru-
bolt holes in door.
4.
Check from inside of door to see if latch is
properly engaged.
INSTALL INSIDE TRIM
1.
Replace inside rose assembly and fasten to
outside rose with the two long thru-bolts.
2.
Press rose cover over inside rose.
Notch in cover must align with either indentation
on inside rose.
NOTE:
Be sure stepped plastic washer is between
inside rose cover and inside rose before
assembling.
INSTALL LEVER
1.
Press lever on lock tube, slightly wiggle and
push until lever engages lever catch and
connector prongs.
2.
Test lever to be sure it is on securely.
Figure 2
Latch Tail
Prong
Rectractor
Rose Post
Lock
Housing
