04. DRILL TOP OF DOOR FOR RELEASE PLUNGER
03. PREPARE DOOR FOR DEVICE AND
TOP & BOTTOM LATCHES
06. INSTALL RODS AND LATCH
05. ATTACH RODS TO LATCHES
of Latch
L
C
(Interior face of door)
RHR shown
LHR opposite
Drill
¹⁄2
" x
³⁄8
" deep
Interior Face of Door Only.
Top of Door
¹¹⁄16
"
A
¹³⁄16
"
¹⁵⁄16
"
Stop Height
¹⁄2
"
⁵⁄8
"-Std.
³⁄4
"
Door Frame
Measure "
Stop Height of Door Frame
" to decide
"
Dimension of A
".
Stop Height
A
Bottom
Latch
Top Rod
Top
Latch
Screw holes facing
center case.
Bottom Rod
Screw holes facing
center case.
of Device
L
C
1¹³/
16
"
Bottom Rod & Latch
Latch Screws
Latch Screws
Top Rod & Latch
SIDE VIEW
End of
Top Rod
End of
Bottom
Rod
NOTE:
D
D
1¹³/
16
"
6 / 12
1. Make the required cut-outs on the interior side of the door
for the exit device as indicated on page 4.
2. Make the required cutouts on the exterior side of the door
using the trim template or door preparation and installation
instructions.
3. Prepare the top and bottom edges of the door for the
latches using the Latch Mounting Preparaton information
on page 4.
Door
Interior
side
Door interior
side
Interior side
³⁄8
"
Thread rod onto latch stud until screw holes on
rods face the center case
Outer edge latch bracket can be removed to
accommodate narrow door stile preparations
for Panic Deivces.
1. Install top latch and latch screws at top of door.
2. Install bottom latch and latch screws at bottom of door.
3. Fine tune the overall rod length by threading the rods in and out
of the latches
Cut top rod if necessary.
See page 11.
