13
These two (2) timer modes are independently enabled. The Doran
Sleeping Child Check (SCC-AM) may be ordered with options already
enabled. Or users may enable timers themselves; however some
disassembly may be required to properly access the programming
jumpers.
If damage occurs from this procedure, Doran will not
warrant the product.
Selecting Timer Options
Jumper
JP1* Open/cut JP1 for Horn ALARM to be triggered 1 Minute after Ignition Off
JP2* Open/cut JP2 will ARM module after 10 continuous minutes with Ignition Input On.
The module may be ARMED either way when P6 is used in this mode.
*Note: For the 24 volt model, pcb versions before 1.11, the instructions for JP1 and JP2 are
reversed due to mislabeling. Pictured is the 12 volt model.
Open JP1 for 1 Min. after stop
ALARM timer.
Open JP2 for 10 Min. ARM
timer.
