Doppler Easy Move Switch 85897EMSWN, Инструкция по сборке и руководство пользователя

Страница: 10 / 100

10
GB
Mounting the wheeled base
In the box, you will find
(Decorative plates available
separately)
Mounting the drawbar
1. Put the drawbar 1 into the drawbar
receptacle
2
so that the 2 spherical
joints 3 lock into the 2 holes 4 of the
drawbar receptacle with an audible
CLICK! (see figure A ).
Mounting the stand tube
1. Place the decorative plate 7 (availa-
ble separately), the rubber disc 6 and
the stand tube
5
on the base
8
so that
the drill holes in the decorative plate,
in the rubber disc and in the stand
tube are aligned with the threads in
the base (see figure B ).
2. Put the shim
11
and the snap ring
9
over the screw 10 and screw the
parts together using a hex key (see
figure C ).
Mounting the shade pole
Using the inserts
Please note!
– Always use inserts 12 that correspond
to the diameter of your shade pole
(see figure
D
).
1. If applicable, insert the required in-
serts 12 in the stand tube 5 (see fig-
ure E ).
Please note!
– The clamping plate located inside the
tube behind the T-screw 13 must be
pushed into the notch 14 of the in-
serts
12
(see figure
E
).
2. Insert the shade pole 15 (see fig-
ure F ).
3. Tighten the T-screws 13 by turning
them clockwise.
Please note!
– First tighten the top and then the bot-
tom T-screw 13 (see figure G ).
Adjusting the length of the
drawbar
Elongating the drawbar
– To elongate the drawbar 1 , pull the
two parts of the drawbar
1
apart until
the spherical joint 16 pops out with an
audible CLICK! (see figure H ).
Shortening the drawbar
– To shorten the drawbar 1 , push the
spherical joint 16 in. At the same time,
push the two parts of the drawbar 1 in-
to one another (see figure
I
).