Doosan G10WMI-2D-T2, Инструкция по установке, эксплуатации и обслуживанию

Страница: 47 / 106

Operating Instructions Operation & Maintenance Manual
22637300 47
VOLTAGE SELECTION/ADJUSTMENTS G240 thru G570
DANGER
!
This set up procedure shall be performed only by knowledgeable qualifed
persons. Ensure all external electrical connections are disconnected.
Use extreme CAUTION when working on electrical components. Battery
voltage (12V or 24V) is present unless the battery cables are
disconnected. Higher voltage (potentially 480V) is present at all times
when the engine is running.
This Generator Set is equipped with direct wiring hook-ups. Any of the
voltages listed below are obtainable by connection to the direct hook-up
terminal block.
NOTICE
Do not hook-up electrical loads until following adjustments have been
completed, otherwise damage to the equipment may result.
SET-UP PROCEDURE
Before starting and making electrical connections:
1. Remove the top cover on junction box (located on the AC Alternator).
2. Remove all nuts and washers from all the studs in the junction box and position
the copper bars on the studs as seen in figure A for 120/208V AC or figure B
for 277/480V AC.
3. Once bars are in position for the voltage you will need, reinstall nuts and
washers and tighten to 50 ft lbs. and replace cover. Note:
When the busbar is
properly installed for either 480V or 208V, it automatically activates the control circuit
Automatic Reconnect Switch located under the busbar.
4.
Start the unit per the Operating Section instructions.