Doosan DX140LCR, Руководство по ремонту

Страница: 556 / 1032

SP001942 Hydraulic System Troubleshooting, Testing and Adjustment
Page 12
Right Swing Operating Circuit
When the swing control lever is pushed to the right swing
position, pilot pressure from the left side pilot valve is directed to
the front
side pump regulator and left half of the control valve.
Output flow from the front pump is then directed through the PR
and SWR ports of the control valve to the swing motor.
Left Swing Operating Circuit
When the swing control lever is pushed to the left swing position,
the control valve spool at the
left side of the control valve moves
in the opposite direction and output flow from the front pump is
directed through the PR and SWL ports of the control valve to
the swing motor.
Swing Relief Valve and Makeup Valve
Whenever the spool is shifted to the neutral mode during swing
operation, the possibility exists that surge pressure in the circuit
- caused by inertial momentum of the upper works and
correspondingly reduced pressure at the opposite motor port -
could produce cavitation in the circuit. To keep that from
happening, a 270 kg/cm
2
(3,840 psi) relief valve is installed in
the swing motor and a large capacity makeup valve is connected
to the entrance port of the hydraulic reservoir, helping maintain
acceptable pressures on both sides of the circuit.
Travel Operating Circuit
Output flow from both halves of the pump assembly is directed
to the right and left travel motors through the right and left sides
of the control valve, and the upper works center joint.
PUMP(F)
PR
CONTROL
VALVE(L)
CONTROL
VALVE(R)
SW SWD
TL
FG015082
PILOT VALVE
Figure 8
PUMP(F)
PR
CONTROL
VALVE(L)
CONTROL
VALVE(L)
SW SWD
TL
FG015083
PILOT VALVE
Figure 9