Page 10/11
LEFT ASSEMBLY
RIGHT ASSEMBLY
22. Place the Princeton Section in its preferred final location in the room.
23. Align the Bunk Bed section with the Princeton Section.
24. Slide the Bunk Bed Inner End Panel up to and flush with the Princeton Section.
25. Align the 3-holes vertically along the Rear Inside Panel Corner Posts (flushed together).
26. Insert Machine Screw (7) through the two posts and into the Female Hex Nut (8).
27. Tighten with the Allen Key (4) provided.
28. Repeat all steps with the holes vertically along the Front Inside Panel Corner Post (flushed together).
29. Install the Slat Roll (L) in the Upper Bunk Bed by rolling it out into position on the Support Cleat.
30. Align the outside edge of the first slat with the end of the Support Cleat on the Inside of the Mattress Support Rail (I).
This aligns the first slat at the proper distance from the Bunk End Panel.
31. The outside edge of the last slat should be flush with the end of the Mattress Rail Support Cleat at the other end of the
Mattress Rail as well.
32. Insert the Wood Screw (10) into the holes in the slats and tighten.
33. Repeat all steps for the Slat Roll (L) in the Lower Bunk Bed.
Ba
ck
si
de
Bac
k si
de
Ba
ck
si
de
Bac
k si
de
7
8
7
8
7
8
7
8
7
8
7
8
7
8
7
8
7
8
4
4
ASSEMBLY INSTRUCTIONS
# 2204 PRINCETON STAIR BUNK - SLATE GREY
