DOMUSA TEKNIK evolution ev 25 hac, Инструкция по установке и эксплуатации

Страница: 9 / 48

7
3.6 Installing the SRFM2/EV Underfloor Heating Kit (Optional)
The procedure for suitably connecting the SRFM2/EV Underfloor Heating Kit to the Evolution EV
HFM boiler is as follows:
- Unplug the boiler from the mains.
- Connect a flow temperature sensor (supplied with the kit) to sensor terminal strip J3 (terminals
15 and 16), first removing the resistance ( Rr ) supplied by default (see “Electrical Connection
Diagram").
- Fit the temperature sensor bulb according to the instructions enclosed with the kit.
- Connect the heating pump to supply terminal strip
J2 on the circuit 1 pump connection (pump
BC
1
; terminals N and 7) (see “Electrical Connection Diagram").
- Connect the pump´s PWM
C
cable to sensor terminal strip J3 (terminals 13 and 14) (see
“Electrical Connection Diagram").
- Connect the 3-way mixer valve motor to supply terminal strip J2 (terminals N, 8 (+) and 9 (-))
(see “Electrical Connection Diagram").
For correct hydraulic installation, carefully follow the assembly and connection instructions
enclosed with the SRFM2/EV kit.
3.7 Installing heating circuit 2 (Optional)
All the models in the Evolution range of boilers are supplied with a circulation pump connected to
heating circuit 1 (BC
1
). In addition to this circuit, all the models are designed to control a second
heating circulation pump in a second heating circuit (circuit 2, BC
2
).
The hydraulic installation of heating circuit 2 should be made using the optional flow circuit (IC') on
the rear of the boiler (see "Diagrams and Measurements"). If there is an SRFM2/EV underfloor
heating kit connected to the optional flow IC', heating circuit 2 should be connected at the
additional sockets provided in the kit (on the boiler T-connectors).
The circulation pump installed in heating circuit 2 must be electrically connected between
terminals N and 6 on the supply connector block
J2
(see "Connection Diagram").