DOMOLIFT CPM1, Руководство пользователя

Страница: 6 / 15

6
4. Settings and configurations of the CPM1
- A Turning the screws indicated in positions "A" you can slide and rotate
at will by the two brackets connected to the projector. Found the correct
positioning, tighten the screws using the supplied wrench.
- B loosening the screws marked in "B" position, is possible slide the main
CPM1 body, to get easily balance of the support. Found the correct
positioning, tighten the screws using the supplied wrench.
- C Turning the knob marked "C" you can adjust the tilt on the vertical
plane of the projector.
- D Turning the two knobs marked “D” you can independently adjust the
inclination of the projector from the horizontal.
ATTENTION!
Always move a knob at a time, and not exceed the adjustment quota indicated
in the figure below (105 to 125 mm). Failure to observe this procedure carries a
risk of loss of control of one of three leveling screws, in this case some damage
and personal injury may occur. In order to grant best results, please respect the
clamping schema as showed in the annex 4 at page 10.
A A
B B
D
C