background image

Important Safety Instructions

6 - 8 Fiveways Boulevard, Keysborough, VIC, Australia 3173

ABN 11 007 125 368

WARNING!

The gate may operate unexpectedly, therefore do not allow anything to stay in the path of
the gate.

Do not disengage the gate opener to manual operation with children/persons or any
objects including motor vehicles within the gateway.

Remove or disengage all gate locks and mechanisms prior to installation of the opener.

Make sure the gate is fully open before driving into or out of the driveway.

When using auto close mode, a 

Photo Electric beam

 must be fitted correctly and tested

for operation at regular intervals.  

Extreme caution 

is recommended when using auto

close mode.  

All safety rules

 must be followed.

ELECTROCUTION!

Do not immerse in or spray the Elite

®

 or the Control box with water .

Disconnect the power cord

 from mains power before making any repairs or removing

covers. Only 

experienced

 service personnel should remove covers from the gate opener.

If the power supply cord is damaged, it 

must

 be replaced by an Automatic Technology

service agent or suitably qualified person.

Connect the gate opener to a properly 

earthed

 general purpose 240V mains power outlet

installed by a qualified electrical contractor.

CAUTION:

Entrapment from 

operating gate 

DO NOT

 operate the gate opener unless the gate is in full view and free from objects such

as cars and children/people. Make sure that the gate has finished moving before entering
or leaving the driveway.

Do not allow children to play with gate controls or transmitters.

In order for the Elite

®

 to 

sense

 an object obstructing the gateway, some 

force

 must be

exerted on the object. As a result the object, gate and/or person may suffer 

damage

 or

injury.

Regularly check to make sure that the 

Safety Obstruction Force

 is working correctly, and

is 

tested

 and set as per 

Section 12 of this manual

. Failure to follow these instructions

could result in 

serious personal injury

 and/or property damage. This test must be

repeated at regular intervals and the necessary adjustments made as required.

If using a key switch, keypad or any device that can operate the gate opener, make sure it is
in a location where the gateway is visible, but out of the reach of children at a height of at
least 1.5m.

For 

ADDITIONAL SAFETY 

protection we 

STRONGLY 

recommend the fitting of a Photo

Electric (Safety) Beam. In most countries Safety Beams are mandatory on all gates fitted
with automatic openers.

Installation

Ensure the gate(s) is in good working order . Faulty gates must be repaired by a qualified
technician prior to Elite

®

 installation.

Frequently examine the installation and mountings for signs of wear, damage or imbalance.
DO NOT use if repair or adjustment is needed since a fault in the installation or an incorrectly
balanced gate may cause injury.

Security

Make sure that the gate is fully closed before leaving the driveway.

Entanglement in or laceration 

from moving gate

Keep hands and loose clothing clear of gate at all times

Keep clear of gate during operation as severe lacerations can occur on sharp edges of gate.

The safety alert symbols below indicate a personal safety or property damage instruction exists.  
READ THESE INSTRUCTIONS CAREFULLY. 

This Elite

®

 Swing Gate Opener is designed and tested to offer safe service provided it is installed and operated in strict 

accordance with the following safety rules. Failure to comply with the following instructions may result in death, serious 

personal injury or property damage.

Supplied by: Dominator

 Garage Doors

P

:

 0800 

366 462

  

    

E

:

 info@

dominator

.co.nz

 

www.

dominator

.co.nz

Содержание SGO-1V4 Elite

Страница 1: ...vision for underground cabling should be made from one post to the other d Ensure sideroom clearance is adequate If there is not enough sideroom available the Minimum Sideroom Kit is required Doc 160043_01 Part 13408 Released 15 12 14 2 7 8 9 6 5 4 3 1 Gate in open position Mount distance Sideroom clearance Hinge distance Wall Pier Mount Distance Hinge Distance 0 50 100 125 150 180 200 220 mm Side...

Страница 2: ...Left Hand Side Installation When gate is closed turn lower cam in an anticlockwise direction until an audible click can be heard from the lower micro switch Open the gate to the required opening position and turn top cam in a clockwise direction until a click can be heard from lower micro switch Once the cams are set to desired limit tighten the screws 2 7 8 9 6 5 4 3 1 If you have limited sideroo...

Страница 3: ...ELITE SGO 1V4 MOUNTING TEMPLATE 1 Place template on wall and drill four 4 holes using the centre point of each hole Datum Line for drive arm 28 Mounting Template ...

Страница 4: ...n may suffer damage or injury Regularly check to make sure that the Safety Obstruction Force is working correctly and is tested and set as per Section 12 of this manual Failure to follow these instructions could result in serious personal injury and or property damage This test must be repeated at regular intervals and the necessary adjustments made as required If using a key switch keypad or any ...

Отзывы: