5
X-TEND A-ROOM
TM
INSTALLATION AND OPERATING INSTRUCTIONS
8.
Grasp the center of the front pole assembly arch,
place it against the roof fabric; and walk towards the
end of the ramp. Place the arch at the front top stitch
line. Wrap the 5 hook/loop belts around the arch
poles to hold place. See Fig. 7.
9.
Keep ball ends of side poles at ramp opening/hinge
and extend the side poles as much as possible
without lifting the X-Tend A-Room
TM
off the ramp. The
side poles should be at an angle. See Fig. 7.
10. Clip the center pole support in the center of the
horizontal frame on the rear frame pole assembly.
The ball socket must be facing toward room. See
Fig. 8.
D. X Tend A-Room
TM
Assembly
1.
Spread the X Tend A-Room
TM
fabric on the cargo
ramp. The zippers should be on the inside and the
open end of the room towards the trailer opening.
2.
Locate the fabric sleeves on each side of the open
end on the rear of fabric assembly. Assemble the
vertical side poles 1C, 1D and 1E of the rear pole
assembly. Place the lock levers in the down/locked
position. Feed the vertical side pole caps down
through the two side panel sleeves, starting at the
top panel.
3.
Assemble the horizontal poles (1A & 1B) of the rear
pole assembly. Place the lock levers in the down
position and slide them through the 4 sleeves across
the roof panel of the fabric. See Fig. 5 & 6.
5.
The fabric and rear pole assembly are moved inside
the trailer door opening. Extend the horizontal frame
of the rear pole assembly equally until they touch the
trailer side walls. Place the levers in the locked
position. See Fig. 6.
Note: The width of the room can be increased by unzipping
the dart (extra fabric) in the center of the roof fabric.
5.
Raise each vertical side pole until the horizontal
pole touches the trailer ceiling. Place the levers in
the locked position. See Fig. 6.
6.
The rear pole assembly will hold the X-Tend A-
Room
TM
in place inside the trailer.
7.
Assemble the front pole assembly inside the X-
Tend A-Room
TM
. See Fig. 7.
FIG. 5
1A
1B
1C
1D
1E
Rear/Frame Pole Assembly
Rear/Frame Pole Assembly
Touches Ceiling
Rear/Frame
Pole Assembly
Touches Side
Floor
FIG. 6
Rear/Frame
Pole Assembly
Touches Side
Side Wall
Side Wall
View From Inside Cargo Trailer Looking Out
FIG. 7
View From Inside Looking Out
Extend Poles Until Fabric Is
Taut Without Lifting Room Off
Ramp
Place Arch
At Top Seam
And Hold In
Place With
Hook/Loop
Belts
FIG. 8
Clip The Center
Pole Support In
Center Of
Horizontal
Frame Of Rear
Pole
Face Ball Socket
Toward Room
Fabric
4.
Insert the horizontal pole assembly into the vertical
side poles to form the rear frame.
Caps
Caps
