Dometic SMRTSTACRV, Инструкция по установке и эксплуатации

Страница: 10 / 88

10
EN
Preinstallation SmartStart RV Soft Start Accessory
Elec Conn
From A/C
Thermostat
Rotary Switch
BLK
YEL
RED
BLU
C,4
L,3
H,6
GRN/YEL
BLU
BLK
GRN/YEL G
L
N
WHT
1
1 L1
2 H
4 C
2
3
4
5
6
13 ADB Wiring Diagram - All AC Unit Models
6 Preinstallation
This section describes the bracket preparation required
before installing the device onto the AC unit.
6 .1 Understanding the Bracket(s) for
the AC Unit
This section describes the bracket configurations based
on the AC unit.
Brisk II
The mounting bracket and z-brackets
should already be assembled and attached
to the device. Go to “Installation” on
page 11.
Penguin II
The mounting bracket should already
be attached to the device. To attach the
necessary hose clamp, go to “Attaching the
Hose Clamp” on page 10.
Blizzard NXT
Other
If the bracket is not assembled and/or not
attached to the device, go to “Bracket
Assembly” on page 26.
6 .2 Attaching the Hose Clamp
This section describes how to attach the hose clamp to
the mounting bracket for all AC units , if applicable.
1. Place the device on its side with the supply side to
the right and the mounting bracket towards you.
I The two LEDs visible on the outside cover of
the device are located on the supply side of the
device.
o o
w w
e e
q q
r r
y y
t t
u u
i i
14 Attaching the Hose Clamp (Supply Side on the Right)
q
LED Location
on the Device Cover
t
Worm Screw
y
Slot - Supply Side
w
Slot - Compressor
Side
u
Bracket
Screws
e
Mounting Bracket
i
Nuts
r
Hose Clamp
o
Device - Supply Side
2. Insert the hose clamp end into the slot on the supply
side of the mounting bracket.
3. Push the hose clamp through to the other side of the
mounting bracket.
I If it is difficult to push the hose clamp through
the mounting bracket, loosen the nuts on the
bracket screws several turns.
4. Push the hose clamp end through the slot on the
compressor side of the mounting bracket.