EN
RMD10T, RMD10XT
Troubleshooting
27
7.1
Fault messages and signal tones
All faults are indicated by a warning symbol, a fault ID and a beep. The beeping lasts
for 2 minutes and is repeated every 30 minutes until the error has been rectified.
If multiple faults occur, the display shows the last fault. The underlying faults are dis-
played after the last fault has been confirmed.
Faults are indicated by a fault code with a warning symbol (
) in the middle of the
TFT display.
The refrigerator is not
adequately cooling.
The ventilation around the
cooling unit is not sufficient.
Check that the ventilation grill is not
obstructed.
The evaporator is iced up.
Check whether the refrigerator door
closes properly. Make sure that the
refrigerator seal fits correctly and is not
damaged. Defrost the refrigerator.
The temperature is set too high.
Set a lower temperature.
The ambient temperature is too
high.
Remove the ventilation grill for a while
so that warm air can escape quicker.
Too much food was placed in the
refrigerator at once.
Remove an item of food.
Too much warm food at once
was placed in the refrigerator.
Remove the warm food and leave it to
cool down before putting it in again.
The refrigerator has not been
operating for very long.
Check the temperature again after four
or five hours.
Fault
Possible cause
Suggested remedy
RMD10_OPM_AUS.book Seite 27 Freitag, 6. Dezember 2019 5:05 17
