4
CONNECTIONS
LP GAS CONNECTION
The gas installation and servicing must be carried out by an
authorised person and conform to all relevant local authori-
ties.
The refrigerator is
not
designed for operation on town gas or
natural gas but for operation on universal LP gas, the pressure
of which must be 2,75 kPa. Check that this is stated on
the data plate. The gas supply system must incorporate an
approved gas pressure regulator to maintain a supply pressure
of 2,75 kPa.
OVERALL DIMENSIONS
RECESS DIMENSIONS
Height
A
Width
B
Depth
C
Height
H
Width
W
Depth
D
mm
766
556
577
756
521
542
Apply a sealing strip
-
to the foremost floor
of the enclosure. The
sealing should provide a
complete isolation of the
appliance’s combustion
system from the vehicle
interior.
Note!
Be careful not to damage the sealing strip when
the refrigerator is put in place.
SECURING THE REFRIGERATOR
Failure to follow the sequence in securing refrigerator in
enclosure can cause leakage between the frame and cabinet!
After the refrigerator is put in place, (insuring a combustion
seal at the front frame), the refrigerator is to be secured in the
enclosure with five screws (not included).
The screws have to be installed in the following order:
Four screws installed through the front frame.
1.
One screw installed in rear base.
2.
In the parts bag there are plugs to be snapped in
the front frame to cover the four screw heads.
INSTALLING THE REFRIGERATOR
It is essential that all maximum or minimum dimensions
•
are strictly maintained, as the performance of the refrig-
erator is dependent on adequate flow of air over the rear of
the refrigerator. The refrigerator must be installed in a sub-
stantial enclosure and must be level, see “
DIMENSIONS
”.
Note!
•
Do not install the appliance directly on carpeting.
Carpeting must be removed or protected by a metal or
wood panel beneath the appliance, which extends at least
full width and depth of the appliance.
The space between the storage cabinet and the top of the
•
refrigerator should be blocked otherwise heat will become
trapped in this space, making the top of the refrigera-
tor hot, thus reducing the efficiency of the unit. All areas
within the recess in which the refrigerator is installed must
be sealed:
Make sure that there is a complete seal between the
-
front frame of the refrigerator and the top, sides and bot-
tom of the enclosure. A length of sealing strip is applied
to the rear surface of the front frame for this purpose.
D
A
H
w
e
i
v
e
d
i
S
D
W
C
B
e
v
o
b
a
m
o
r
f
w
e
i
V
2
1
DIMENSIONS
The following dimensions offer adequate space for service
and proper installation.
CAUTION
Check that the gas supplied to the refrigerator is at the
correct pressure.
UNIVERSAL
Содержание RM2350
Страница 12: ...54 219 MAW41A01...
