EN
RC(S)(L)(D)10-Series
Installing the refrigerator
17
4.2
Installing the condensate drain
I
Install the condensate drain as follows:
➤
Run the condensation water hose from the refrigerator through an opening in the
floor which goes outside.
4.3
Connecting the power supply
A
1. Determine the required cross section of the cable in relation to the cable length
according to fig.
2. Connect the cables to the AMP connector of the refrigerator (fig.
3. Connect the other ends of the cables to the
12 V
g
power supply:
A
–
as directly as possible
–
rd (red): with a fuse protection (10 A) fitted to the positive (+) pole
–
bk (black): to the negative (–) pole
NOTE
•
Condensation can form inside the refrigerator due to frequent door
opening, incorrectly stored food or food that is stored when it is too
warm.
•
Condensation must be drained with a constant slope.
NOTICE! Damage hazard
•
The electrical installation and repairs may only be performed by a
specialist in accordance with the applicable national regulations and
standards.
•
To avoid voltage loss and therefore a drop in performance, the cable
should be kept as short as possible and should not be interrupted if
possible. For this reason avoid additional switches, plugs or power
strips.
•
Before connecting check whether the operating voltage and the bat-
tery voltage correspond (see type plate).
NOTICE! Damage hazard
•
Make sure the polarity is correct.
•
Fit the positive (+) cable with a 10 A fuse.