INTRODUCTION
Radome Environmental Control Unit
2
L-2283 ENGLISH
W
ARNINGS
AND
N
OTICES
WARNING
This manual contains essential safety information concerning the safe and proper installation, operation, and
maintenance of your Radome ECU. It is very important that you read and understand the contents of this manual
thoroughly before installing or using the equipment. You should keep this manual on your boat for future reference.
Failure to follow Dometic approved installation, start-up, operation, and troubleshooting procedures will void the
warranty. If there are any statements in this manual that you do not understand, contact your local dealer for
assistance or the Dometic Marine Service Department:
•
Phone:
+1 804-746-1313 or +1 954-973-2477 (8AM - 5PM US Eastern Time)
•
Fax:
+1 804-746-7248 or +1 954-979-4414
•
Email:
DANGER
ELECTRICAL SHOCK HAZARD. DISCONNECT VOLTAGE AT MAIN PANEL OR POWER SOURCE BEFORE OPENING
ANY COVER. FAILURE TO COMPLY MAY RESULT IN INJURY OR DEATH.
DANGER
The equipment referenced in this manual operates with compressed refrigerant at high pressures. Proper care must
be taken during installation, operation, and servicing to prevent injury or loss of life due to improper procedures.
DANGER
This equipment is not ignition protected per CFR 183.410 and may not be installed in areas that may be exposed to
flammable gases. Do not install in spaces containing gasoline engines, tanks, LPG/CPG cylinders, regulators, valves
or fuel line fittings. Failure to comply may result in injury or death.
WARNING
To minimize the hazard of electrical shock and personal injury, this component must be effectively grounded. Refer to
the installation guidelines for further information.
NOTICE
Some equipment may be shipped with specific installation sheets or wiring diagrams that may supersede the
information located in this manual. Dometic reserves the right to update or change any information located herein at
any time and without prior notice.
NOTICE
Contains R-417A fluorinated greenhouse gas in hermetically sealed equipment. Refer to the condensing unit's product
data plate label for quantity of refrigerant shown in weight, global warming potential (GWP), and equivalent tonnes of
CO2 (tCO2e). Any refrigerant added should be noted on unit label.
