6
EN
Installation
PRO TRIM™ Single/Dual Bezel Switch Assembly
e
q
w
6
Remove the Bezel
q
Bezel
e
Steering Wheel Shaft
w
Countersunk Holes
6. Remove the bezel from the steering wheel shaft,
taking care to leave the attachment screws in the
countersunk holes in the bezel.
r
q
w
e
7
Attach the Bezel
q
Bezel
e
Screws
w
Switch Assembly
r
Steering Wheel Shaft
7. Attach the switch assembly to the bezel using the
screws provided:
a. If the bezel has no recessed holes, use two
7/16 in. screws and lock nuts (provided).
b. If the bezel has recessed holes, use two 5/8 in.
self-tapping screws (provided).
8. Depending on the option chosen in step 4, feed the
wires:
– Through the bezel and dash.
– Through the dash.
– Underneath the dash.
9. Place the bezel with attached switch assembly over
the steering wheel shaft (see Figure 7) and tighten
the bezel attachment screws.
10. Proceed to “Wiring the Connections to the Marine
5 .2 Mounting on a Rack Steering
System (Non-Tilt)
q
w
8
Rack Steering System Bezels
q
Rack Steering System
Bezel
w
Back Mount Rack
Steering System
Bezel
The helm of the Rack Steering System (1984–present)
can be identified by the plastic bezel (trim piece)
through which the steering wheel shaft passes.
1. Remove the steering wheel and retain the hardware
for use during reinstallation. Refer to your steering
system and wheel manufacturer instructions to
ensure proper removal of the steering components.
