Operation
PJS 1000
EN
16
✔
The “IN” indicator stops flashing and is displayed permanently.
Checking the state of charge
➤
Press the
button to switch the jump starter on.
✔
The LCD display shows the state of charge (fig.
, page 4) between 0 % (discharged) and 100 % (fully
charged).
8.5 Using the LED flashlight
!
I
The LED flashlight offers three operating modes:
•
Continuous light:
The LED flashlight lights up continuously.
•
Strobe light:
The LED flashlight is flashing at a constant interval.
•
SOS signal:
The LED flashlight is flashing the SOS signal pattern.
➤
To use the LED flashlight and switch between the different operating modes, proceed as shown (fig.
8.6 Jump-starting vehicles
!
!
A
CAUTION! Risk of injury
Avoid looking directly into the LED flashlight as this may damage your eyes.
NOTE
The operation of the LED flashlight is not available during charging.
WARNING! Electrocution hazard and fire hazard
• Do not connect the two battery clamps together.
• Do not use battery clamps other than those provided.
• Observe both the required connection and disconnection sequence of the battery
clamps and the correct polarity.
CAUTION! Risk of injury
Do not put your fingers or hands into the battery clamps.
NOTICE! Damage hazard
• Do not jump-start a deeply discharged or defective vehicle battery.
• Do not attempt to jump start the vehicle more than 3 times in a row. If the vehicle
does not start after 3 attempts, the vehicle should be checked by authorized work-
shops.
Dometic_PJS1000_4445103806_OPM_EMEA17_202x-xx-xx.book Page 16 Friday, October 21, 2022 8:44 PM