Fitting the camera
PerfectView
EN
12
•
Observe the fastening instructions:
– There must be sufficient space behind the chosen installation location to be able to carry
out the mounting procedure.
– Suitable measures must be taken to prevent water penetrating through any holes made
(e.g. by using screws and sealant and/or spraying the outer attachment parts with sealant).
– The location on the body where you wish to attach the camera must be rigid enough to
allow the camera to be tightly fastened.
•
Check beforehand that there is sufficient space on the other side for the drill head to come out
(fig.
1
, page 2).
•
If you are not sure about the location you have chosen, ask your vehicle manufacturer or dealer.
I
To perform the installation, proceed as follows:
➤
Hold the lower camera holder on the selected installation location and mark two drilling points
(fig.
6
, page 4).
➤
Using a hammer and center punch, gently pre-punch the previously marked points to prevent
the drill head from slipping off.
If you want to screw on the bottom camera holder with self-tapping screws
A
➤
Drill the holes, with a Ø of 2 mm, at each of the markings.
➤
Deburr all drill holes and apply rust-protection.
➤
Place the insulating plate (fig.
3
3, page 2) on the installation location of the lower camera
holder.
The insulating plate also serves as a seal and paint protection.
➤
Screw on the camera holder using the self-tapping screws.
NOTE
We recommend greasing the threads of the bolts to prevent corrosion.
NOTICE!
Self-tapping screws may only be fastened to steel metal with a minimum thickness of
1.5 mm.
CAM301-IO-16s.book Seite 12 Dienstag, 4. September 2018 10:59 10
