9
Patio Awning
Open Button
Programming
Button
Programming
Indicator Light
FIG. 5.2
Programming
Indicator Light
Programming
Button
click is present switch is defective. Replace
switch.
3.3
Wind Sensor Toggle Switch
The toggle switch turns the wind sensor feature
on and off. When the switch is in the DISABLE
(OFF) position the awning will not automatically
retract if threatening winds are present. When in
the ENABLE (ON) position the awning will auto-
matically retract if the wind exceeds the preset
setting.
If one or more of the above tests do not perform
properly the circuit board is probably defective.
Replace the control box assembly.
3.4 Wiring Diagram (See Page 7, FIG. 3.4A & 3.4B)
SECTION 4 Remote Switch
4.1 If awning does not work using the remote switch,
disconnect both the WeatherPro and the Oasis
Elite pigtail. Check for 12VDC on the control box
end of the pig tail. See Section 3.1.4 and 3.1.6. If
there is 12 VDC at this point depress the remote
switches and listen for the relays to click. If no
clicking is heard replace appropriate remote
switch. See FIG. 4.1.
EXTEND
RETRACT
FIG. 4.1
SECTION 5 Remote Key FOB
5.1
The remote key FOB is powered by a 12 VDC
type 23A battery. The operational range is up to
30 feet. This distance will vary depending on the
battery condition. To change the battery, remove
screw in back of key FOB and replace it with a
type 23A 12VDC battery. See FIG. 5.1.
PATIO
DOOR
EXTEND
EXTEND
RETRACT
RETRACT
23A 12V
Battery
FIG. 5.1
5.2
Programming Key FOB
The electronic board is susceptible to static
charge. Do not insert metal object inside con-
trol box. Damage to electronic board will oc-
cur if a short is created. Use only a noncon-
ductive material to depress programming
button inside control box.
5.2.1 Remove four (4) screws from control box
cover and lift cover to expose circuit board.
See FIG 5.2.
5.2.2 Press and release programming button .
Programming indicator light will illuminate.
5.2.3 Press and hold the key FOB patio awning
open button for four (4) seconds.
5.2.4 Release the key FOB patio awning open
button. This completes the programming
process.
5.2.5 Place control box cover on control box and
secure with four (4) screws .
5.2.6 Test awning operation.
