Dometic miniBar RH 429LDAG, Руководство по эксплуатации

Страница: 7 / 60

7
The frost will melt and the defrost water will run
through the drain tube from the drip channel into an
evaporating vessel located at the bottom rear of the
refrigerator. (Fig. 5) The defrost water will evaporate
automatically into the circulating air and the vessel will
not need emptying.
Figure 5.
To switch off the unit, disconnect the refrigerator from
the electricity supply and leave the cabinet door open.
After defrosting the cabinet interior should be wiped
out with a clean, damp cloth.
7.1. Automatic defrost function
The first defrosting phase commences 39 hours after
the start and lasts for two hours.
After this, the device operates for 22 hours at a time,
followed by a defrosting period of 2 hours.
7.2. Interior light
(fig. 6.)
Two light-emitting diodes (A) on an electronic PCB
illuminate the cooling compartment when the door is
opened.
Two sensors (B) control whether the door is open or
not and the LEDs and the door control as well will
work accordingly.
Figure 6.
7.3. Automatic Door Control LED (ADC)
(optional)
The LED (Fig. 7.A) mounted to the screw down foot
lower door hinge indicated whether the miniBar door
has been opened. If so then:
1. Open the miniBar, check the content in the
compartement and if necessary, replenish.
B
A
2. Reset the door control signal by helding the
Remote control against the door opening sensor
(Fig. 6. B) and push the button.
3. Close the miniBar.
Figure 7.
8. Reversing the door hang
(Fig. 8.)
Reversing is suggested to perform in the following
way, in order to avoid breaking of the hinge bolt:
Disconnect the mains
Lay the appliance down carefully on its back
Figure 8.
Take down the two foot-extension (1) pieces by
removing the two screws (2)
Remove the four screws (4) and take out the two
fixing feet (3)
Remove the four screws (7) the upper hing (5)
and the cover cap (6)
Remove the door (8), together with the upper
hinge (5), from the housing
Insert the upper hinge (attached the miniBar)
and the covering plate in the slot on the opposite
side and secure with four screws (7).
Insert the door on the upper hinge and place it.
Mount the fixing feet (3) with hinge bolts (9)
placed into the opposite side of the feet
Mount the two foot-extension pieces (1)
Check that the door closes easily and is sealed
properly.
4
5
11
22
6
3
8
7
9
A
GB