Dometic MF20-60, Руководство по эксплуатации

Страница: 6 / 14

7. Ventilation grills, if used, must have
3. Cleaning
Clean the refrigerator thoroughly at intervals, as
necessary. Remove the shelves; these parts, as well as the cabinet interior and the door should be
washed with a warm solution of sodium bi-carbonate. Finally wipe over with a cloth rinsed in warm
water only, and dry with a clean cloth. Do not wash any plastic parts in water that is more than hand
warm, and do not expose them to dry heat. The outside of the cabinet should be wiped down regularly
with a clean, damp cloth.
NEVER USE STRONG CHEMICALS OR ABRASIVE CLEANING MATERIALS ON ANY PART OF
THE CABINET.
4. Positioning the appliance
When first using this refrigerator please consider the following points:
ENSURE REFRIGERATOR IS LEVEL
a. THE PIPEWORK AT THE BACK GETS HOT IN USE
b. THE REFRIGERATOR HAS NO 'MOTOR' AND IS THEREFORE VIRTUALLY SILENT
c. ALLOW AT LEAST 3 HRS. FOR SIGNS OF
COOLING
During the refrigeration process, the appliance
gives off heat from the condenser (under the upper part of the rear cover) into the surrounding air.
The more ventilated the condenser is, the more effective the refrigeration will be.
The other condition for satisfactory operation is that the appliance is levelled. This could be checked
by placing a glass of water on top of the appliance.
It is important that the appliance is not directly exposed to radiated heat (sunlight, radiator, near an
oven, etc.).
4.1. Installation instructions
The refrigerator is equipped with an electrically heated absorption cooling unit which is virtually silent
in operation. The fridge is designed for free-standing installation, but can be built-in if the following
conditions are complied with to ensure satisfactory operation and maximum cooling efficiency.
IMPORTANT
Please follow the installation details below carefully Guarantee is valid for products installed
as described only.
1. 1. The refrigerator must be level both directions
2. 2. There should be 20 mm clearance to the wall
3. 3. Ventilation must be provided as shown in alternatives A, B, C or D (fig 2-3)
4. 4. The ventilation duct must at least measure 105 mm x the width of the refrigerator
5. 5. Only the entire cooling unit must project into the duct as shown
6. 6. Air passing through the duct must not be preheated by any source of heat