EN
Using the device
CS102, CSG103
16
I
➤
Proceed as follows:
–
Igniting the burners: fig.
–
Igniting the grill burner (
CSG103 only
): fig.
➤
If the burner does not ignite after 3 attempts, turn off the gas and wait 10 seconds
for the gas to clear.
➤
Try again with the piezo igniter or light the device manually using a long match or
long neck lighter (fig.
, page 8). Do not use a cigarette lighter.
➤
After lighting, check that the burner has properly ignited. The flames must be
burning along the whole length of the burner.
Using the pan
➤
Proceed as follows (
CSG103 only
Turning off the device
➤
Proceed as follows: fig.
Packing up the device
!
➤
Disconnect the device from the gas supply.
➤
Clean the device (fig.
➤
Stow away the pan and rack (
CSG103 only
) and close the lid.
Replacing the gas cylinder
!
NOTE
•
While it is operating, you will be able to hear a slight noise caused by
the gas flowing out. This is completely normal.
•
Smoke can occur when using it for the first time. This is caused by
deposits of machine oil burning and stops after approx. 10 minutes.
CAUTION! Beware of burns
The device is very hot when you use it. Leave the portable grill to cool
down before you clean, dismantle or transport it.
WARNING! Beware of injury
Change the gas cylinder in a well-ventilated location.
Ensure that there are no open flames in the vicinity.
Only replace the gas cylinder when the portable grill is switched off.
DometicCS102-CSG103_IOM_4445103024_APAC(en)_.book Seite 16 Donnerstag, 9. April 2020 11:02 11