Dometic FlyTec FT100, Инструкция по установке и эксплуатации

Страница: 13 / 160

EN
FlyTec FT100 Installing the flyscreen
13
➤
Measure the installation opening in your vehicle and check whether the
dimensions of the flyscreen fit your vehicle.
➤
Remove the rubber buffer from the door (fig.
3
, page 4).
Trimming the opening (depending on the vehicle)
➤
If necessary, remove add-on parts that interfere (such as bottom end strips or
bodywork) in the installation opening.
To be able to install the skirting board (fig.
1
1, page 3) flush, you may need to trim
the existing fixtures (such as floors or cabinets).
➤
Mark the following (fig.
2
, page 3):
– Size A = 18 mm (width of the bottom part of the skirting board), measured
from the edge of the sheet-metal bodywork
– Size B = 3 mm (height of the skirting board).
➤
If necessary, trim the existing fixtures with a suitable tool, such as an oscillating
saw.
➤
Smooth and clean the cut edges.
5.3 Pre-installing the rails
Cassette profile, skirting board and upper guide rail
The cassette profile, skirting board and upper guide rail must be assembled lying on
the ground (fig.
4
, page 4) before being placed in the vehicle.
➤
Check whether the cover profile can be inserted between the C pillar and interior
fittings. You may need to adapt the contour by trimming.
➤
Guide the lower slider of the handle strip along with the cassette profile into the
skirting board.
➤
Pull the cassette and handle strip apart by a bit and then slide the cassette profile
onto the nose on the skirting board.
➤
Secure the cassette profile with the screw (M5 x 30 mm) and M5 nut on the upper
guide rail.
➤
Insert the cover for the C pillar into the cassette so that the drill holes are located
one above the other and secure the two components with three blind rivets
(4 x 8 mm with stainless steel mandrel) without riveting them (fig.
5
, page 5).
➤
Secure the deflection screw M4 (fig.
6
1, page 5) to the skirting board.
FT100-IO-16s.book Seite 13 Montag, 3. April 2017 6:37 18