7
Figure 8.
11. Replacing the decorative
door panel,
Fig. 9
Figure 9.
Remove the mounter screws (1) of the forehead
panel.(3)
Remove rosette (2) (in case of with lock version fridge).
Lift and remove the forehead panel.(3)
Slide the decorative panel (4) out of the door frame
and insert the new panel (thickness max. 2 mm).
Place back the forehead panel,rosette and screw in
reverse sequence.
12. Customer service
Before you call a service engineer, carry out the
following simple tests:
Is there a power failure? Check the fuses.
Is the plug firmly connected to the socket and is the
socket switched on? Check the socket by plugging
in another appliance, e.g. a table lamp.
Is the thermostat at the correct setting?
Has the door not been closed properly causing the
inside temperature to rise too quickly?
Is the refrigerator level?
Has the ventilation become obstructed?
If after checking all the above points, the refrigerator
is still not working satisfactorily, contact your nearest
service engineer. State the problem, model, product-
and serial-number.
1
1
3
2
4
(Details of the model, product- and serialnumber
are to be found on the data label in the top left of
the inside compartment.)
This refrigerator is equipped with overheating
protection. An authorised service technician can
check whether this has been triggered or not.
In the event of a fault developing, contact your
nearest Service Centre-see local telephone
directory.
13. Putting into operation
Technical data:
13.1. Connecting to electrical mains
The appliance may only be operated from
nominal voltage mains as shown on the data
plate. The appliance mains plug may be connected
to a mains socket earthed in accordance with
regulations.
Any electrical work required to install this appliance
should be carried out by a qualified electrician or
competent person.
The manufacturer declines any liability should
these safety measures not be observed.
Electrical Requirements
Before switching on, make sure the electricity
supply voltage is the same as that indicated on the
appliance rating plate.
Only for UK:
The appliance is supplied with a 3 amp plug fitted.
In the event of having to change the fuse in the plug
supplied, a 3 amp ASTA approved (BS 1362) fuse
must be used. Should the plug need to be replaced
for any reason, the wires in the mains lead are
coloured in accordance with the following code:
Green and Yellow:
Earth
Blue:
Neutral
Brown:
Live
Model
DS 300 H
DS 600 H
Type
DS 20-60
DS 20-60
Gross volume
28,1 litre
52,6 litre
Mains operation
220 - 240V (AC)
220 - 240V (AC)
Input
65W
85W
Energy consumption 0,76 kWh/24h
0,88 kWh/24h
Climate class
SN
SN
Refrigerant
151g H
2
O + 101g NH
3
157g H
2
O + 105g NH
3
Downloaded from
www.Manualslib.com
manuals search engine
