Dometic DOTRC11B, Руководство по установке

Страница: 10 / 18

ELECTRICAL SHOCK HAZARD!
UNPLUG UNIT BEFORE WORKING ON IT.
• DO NOT PULL OR STRETCH THE BLOWER WIRING!
Pulling and stretching the blower wiring could result in electrical shock.
Remove the two vent grille mounting screws and tip the vent
grille forward, then lift it out. See Figure 10.
Loosen the two rod retainer screws behind the vent grille.
See Figure 10-1, remove the wall mounting plate from the
back of the oven and set aside.
WALL-VENTED INSTALLATION:
Go to STEP 4 on page 12.
ROOF-VENTED INSTALLATION:
1. Remove and save the two blower screws, See Figure 11.
2. Carefully lift the blower unit out of the microwave oven,
slipping wires out of clips.
3. Rotate blower unit end over end. Rotate the unit 90° so
that the exhaust ports face the upper of the unit. See
Figure 12. Slip wires into clips at the bottom left hand
corner of blower unit. See Figure 13.
4. Place blower unit back into cabinet. Check that the exhaust
ports face the upper of the cabinet. See Figure 14.
5. Tighten the two blower screws. See Figure 14.
NOTE: If you want to install this microwave oven properly,
you should be careful to tighten the blower screws.
For a roof-vented installation, use the screw holes
labeled “A” in figure 18 on page 11.
STEP 3:
PREPARE THE VENTING BLOWER
blower
screw
exhaust ports
Figure 11
Figure 12
blower
unit
Figure 10
Figure 10-1
blower
screw
blower
unit
exhaust
ports
Figure 14
exhaust ports
Figure 13
wire clips
W A R N I N G
– 10 –