3
3. REMOVING SCREWS FROM
OUTER CASE
A. Remove four (4) screws securing the front side of the
outer casing. See FIG. 4.
B. Remove only one (1) screw securing the outer case.
(Right-upper corner on the back plate).
C. Place screws to the side to be reinstalled in later step.
D. Install foam tape to bottom of microwave along both
sides and back edge. See FIG. 4.
4. MOUNTING OF THE TRIM FRAME
A. Insert the trim frame onto the microwave oven as
shown in FIG. 5. Make sure the upper side of the trim
frame is larger than the lower side.
B. Secure the right side of the trim frame with two (2)
screws.
5. MOUNTING VENTILATION GUIDE
DUCT
A. Install the ventilation guide duct as shown in FIG. 6.
B. Secure the front side of the ventilation guide duct and
left side of the front trim at the same time with two (2)
screws.
C. Secure the rear side of the ventilation guide duct with
one screw.
6. INSTALLATION OF MICROWAVE
OVEN IN OPENING
The weight of the microwave oven may exceed
your lifting ability. We recommend assistance
.
A. Plug power cord of microwave oven into grounded
receptacle in the rear wall.
B. Insert the microwave oven into the cabinet opening.
Make sure the trim frame is completely pushed
back against the front wall and that the foam tape
on the bottom of the oven is still in place.
C. Finally, secure the trim frame with six (6) truss head
screws (not supplied). See FIG. 7.
FIG. 6
FIG. 7
FIG. 5
FIG. 4
FOAM TAPE
