3
EN
Self-Contained Air Conditioning System
Explanation of Symbols and Safety Instructions
• The installation must comply with all applicable local
or national codes, including the latest edition of the
following standards:
– American Boat and Yacht Council (ABYC)
– ANSI/NFPA70, National Electrical Code (NEC)
1 .4 General Safety Messages
WARNING: CARBON MONOXIDE HAZARD .
Failure to obey the following warnings could
result in death or serious injury:
• Do
not
install or operate a self-contained air
conditioner in the bilge or engine room areas, or
near an internal combustion engine. Ensure that the
selected location is sealed from direct access to bilge
and/or engine room vapors.
• Verify the condensate drain line is properly installed
and sealed. Do
not
terminate the condensate drain
line within 3 ft. (0.91 m) of any outlet of an engine
or generator exhaust system, in a compartment
containing an engine or generator, or in a bilge,
unless the drain is connected properly to a sealed
condensate or shower sump pump. If the drain line is
not
properly installed, dangerous fumes may travel
up the drain line and contaminate the living quarters.
• Do
not
install the air conditioning unit in a location
where it can circulate carbon monoxide, fuel vapors,
or other noxious fumes into the boat’s living spaces.
WARNING: ELECTRICAL SHOCK, FIRE, AND/OR
EXPLOSION HAZARD .
This appliance is
not
intended for use by persons
(including children) with reduced physical, sensory,
or mental capabilities, or lack of experience
and knowledge, unless they have been given
supervision or instruction concerning the use of the
appliance by a person responsible for their safety.
Children should be supervised to ensure that they
do
not
play with the appliance. Cleaning and
user maintenance shall
not
be made by children
without supervision. This appliance should
not
be
accessible to the general public. Failure to follow
these precautions could result in death or serious
injury.
WARNING: EXPLOSION HAZARD .
Do
not
install the air conditioning unit in a location
containing gasoline engines, tanks, LPG/CPG
cylinders, regulators, valves, or fuel line fittings.
Unless labeled otherwise, self-contained units
do
not
meet federal requirements for ignition
protection. Failure to obey this warning could result
in death or serious injury.
WARNING: ELECTRICAL SHOCK HAZARD .
Failure to obey the following warnings could
result in death or serious injury:
• Be sure to effectively ground the air conditioning unit
to minimize the electrical shock hazard. Refer to the
installation guidelines for further information.
• Each air conditioning unit installed requires a
dedicated circuit breaker. If there is only one air
conditioning unit installed, the seawater pump
does not require a circuit breaker. If two or more air
conditioning units use the same seawater pump, the
pump wires will be connected to a pump relay panel
(PRP), which in turn has its own dedicated circuit
breaker sized for the pump (20 A max). Refer to the
the wiring diagram furnished with the PRP. Electrical
connections in the bilge and/or below the waterline
should use heat shrink type butt splices.
• Field wiring must comply with ABYC electrical codes.
Power to the unit must be within the operating
voltage range indicated on the data plate. Properly
sized fuses or HACR circuit breakers must be installed
for branch circuit protection. See the data plate for
the maximum fuse/circuit breaker size (mfs) and
minimum circuit capacity (mca).
NOTICE:
This appliance contains fluorinated
greenhouse gases in hermetically sealed equipment.
Refer to the condensing unit’s product data plate label
for the quantity of refrigerant shown in weight and GWP.
The refrigerant added should be noted on the unit label.
I
The PRP triac must have its mounting screw installed
in order to dissipate heat.
