Dometic CoolMatic CRP 40S, Инструкция по установке и эксплуатации

Страница: 21 / 80

EN
CRP40 Troubleshooting
21
10 Troubleshooting
Compressor does not run
Fault Possible cause Remedy
U
TERM
= 0 V There is an interruption in the
connection between the battery and
the electronics. Establish a connection.
Main switch faulty (if installed). Replace the main switch.
Additional supply line fuse has blown
(if installed). Replace the supply line
fuse.
U
TERM

U
ON
Battery voltage is too low. Charge the battery.
Start attempt with
U
TERM

U
OFF
Loose cables.
Poor contact (corrosion).
Establish a connection.
Battery capacity too low. Replacing the battery.
Cable cross section too small. Replace the cable
(fig.
9
, page 6).
Start attempt with
U
TERM

U
ON
Ambient temperature too high. –
Insufficient ventilation and/or air
supply. Move the refrigerator to
another location.
Condenser is dirty. Clean the condenser.
Fan defective (if installed). Replace the fan.
Electric circuit between
the pins in the compres-
sor interrupted Defective compressor. Replace the compressor.
Usage when the
ambient temperature is
too low The compressor only starts up at an
ambient temperature of more than
+16 °C. Only switch on the refrig-
erator at an ambient tem-
perature of more than
+16 °C.
U
TERM
Voltage between the positive and negative terminals of the electronics
U
ON
Cut-in voltage of the electronics
U
OFF
Cut-off voltage of the electronics